Corticospinal Excitability After rTMS in Spinal Cord Injury Patients
NCT ID: NCT03014999
Last Updated: 2021-06-30
Study Results
The study team has not published outcome measurements, participant flow, or safety data for this trial yet. Check back later for updates.
Basic Information
Get a concise snapshot of the trial, including recruitment status, study phase, enrollment targets, and key timeline milestones.
COMPLETED
NA
12 participants
INTERVENTIONAL
2016-12-31
2017-06-30
Brief Summary
Review the sponsor-provided synopsis that highlights what the study is about and why it is being conducted.
Related Clinical Trials
Explore similar clinical trials based on study characteristics and research focus.
rTMS and Body Weight-support Treadmill Training After Incomplete Spinal Cord Injury
NCT03394560
Effects of Transcranial Magnetic Stimulation in Incomplete Spinal Cord Injury
NCT02899637
The Effect of rTMS in Patients With Spinal Cord Injury (rTMS:Repetetive Transcranial Magnetic Stimulation)
NCT04372134
Efficacy of rTMS Treatment After Spinal Cord Injury
NCT06464744
Effects of Trans-spinal Magnetic Stimulation on Cortical Excitability in Healthy Individuals
NCT07026760
Detailed Description
Dive into the extended narrative that explains the scientific background, objectives, and procedures in greater depth.
1. Quantity and quality of sleep: It will be enquired how many hours the volunteer slept in the last night. The quality of the sleep will be measured through an analogue scale graded from 0 (worst quality of sleep) to 10 points (best quality of sleep).
2. Type of eating: All the individuals will be asked about ingestion of food and drinks that could change the cortical excitability (e. g.; coffee, chocolate, energetic, soda e etcc). If positive, researchers will record the time since of ingestion and quantify the amount of food.
3. Fatigue and motivation level: It will be measured through an analogue scale graded from 0 (lower fatigue or motivation levels) to 10 points (greater fatigue or motivation levels).
4. Spasticity: It will be assessed by the modified Ashworth scale ranging from 0 to 4. Performs the passive drive member to be measured and observing the time it arises the resistance difficult the passive movement. This scale will be tested bilaterally in the muscles of the lower limbs, the tested muscles are the quadriceps, adductors, hamstring, dorsiflexors, hip flexors and flexors plant. The scale always applies by the same evaluator.
5. Spinal cord activity: the level of excitability of spinal cord will be measured through the following outcomes:
• Hoffman reflex (H reflex): the H reflex will be elicited by a percutaneous electrical stimulation on tibial nerve delivered on popliteal fossa and recorded the electromyographic responses from the soleus muscle. The values of maximal H reflex, M wave and maximal H reflex and maximal M wave ratio (H/M ratio) will be obtained through a recruitment curve.
The recruitment curve will start with a stimulus intensity delivered from 2 milliampere (mA) and increasing on steps of 1 mA until to M wave curve stabilization (no increasing of the M wave amplitude).
• Homosynaptic depression (HD): the HD will be obtained through a serie of two consecutive stimuli separated by a interstimulus interval (from 30 ms until 10.000 ms). The stimuli will be delivered on popliteal fossa and the electromyographic responses from soleus muscle will be recorded. The stimuli will be delivered with the intensity necessary to produce the maximal H reflex (this information will be available in the recruitment curve as stated before). The difference between the first and the second stimuli for each interstimulus interval will give rise to the recovery curve.
6. Cortical excitability: the cortical excitability will be measured through the motor evoked potential (MEP) through simple pulse transcranial magnetic stimulation (BiStim2, Magstim, UK) Initially, the higher cortical representation area (hotspot) of first right dorsal interosseous (FDI) muscle will be determined through a figure-eight coil connected to the magnetic stimulator held manually at 45 degrees from the midline, will be placed over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold (RMT) by finding the lowest stimulator output that elicit motor evoked potential (MEP) at least 50 microvolts (μV). After determined the RMT, the MEP value will be obtained through twenty suprathreshold (130% of RMT) stimuli that will be delivered on primary motor cortex (C3).
7. rTMS: Initially, the higher cortical representation area (hotspot) of first right dorsal interosseous (FDI) muscle will be determined through a figure-eight coil connected to the magnetic stimulator (Rapid2, Magstim, UK) held manually at 45 degrees from the midline, will be placed over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold (RMT) by finding the lowest stimulator output that elicit motor evoked potential (MEP) at least 50 microvolts (μV). After determined the RMT, the coil will be positioned over the scalp (Cz - 10/20 System) and based on previous studies will be performed rTMS protocols. Low frequency protocol: 1 hertz (Hz), 90% RMT, 1500 stimuli (1 train). High frequency protocol: 10 Hz, 90% RMT, 45 trains, 40 stimuli per train, inter interval of 28 seconds, 1800 stimuli. Sham rTMS will be performed with low frequency protocol using two coils. The first one - connected to the stimulator - will be positioned on a coil support close to the volunteer but not visible. Therefore, characteristic stimulation noises will be audible. The second - disconnected to the stimulator - will be placed over left primary motor area. After each rTMS session, presence of adverse effects will be computed.
8. Spasticity: this evaluation will be performed immediately after (T0), thirty minutes after (T1) and 1 hour after (T2) the rTMS. The procedures will be conducted following the same protocol.
9. Spinal cord activity: this evaluation will be performed immediately after (T0), thirty minutes after (T1) and 1 hour after (T2) the rTMS. The procedures will be conducted following the same protocol.
10. Cortical brain activity: this evaluation will be performed after each revaluation of spinal cord activity (T0, T1 and T2). The procedures will be conducted following the same protocol.
Conditions
See the medical conditions and disease areas that this research is targeting or investigating.
Study Design
Understand how the trial is structured, including allocation methods, masking strategies, primary purpose, and other design elements.
RANDOMIZED
CROSSOVER
OTHER
QUADRUPLE
Study Groups
Review each arm or cohort in the study, along with the interventions and objectives associated with them.
High frequency rTMS
Volunteers will be submitted to high frequency of repetitive transcranial magnetic stimulation (10Hz)
High frequency rTMS (repetitive Transcranial Magnetic Stimulation)
Higher cortical representation area of first right dorsal interosseous muscle will be determined through a figure-eight coil connected to the magnetic stimulator (Rapid2, Magstim, UK) held manually and at 45 degrees from the midline over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold by finding the lowest stimulator output that elicit motor evoked potential at least 50μV. After determined the RMT, the coil will be positioned over the scalp (Cz - 10/20 System). Thereafter, RMT will be measure. rTMS protocols was based on previous studies. High frequency protocol: 10Hz, 90% RMT, 45 trains, 40 stimuli per train, inter interval of 28s, 1800 stimuli. After each rTMS session, presence of adverse effects will be computed.
Low frequency rTMS
Volunteers will be submitted to low frequency of repetitive transcranial magnetic stimulation (1Hz)
Low frequency rTMS (repetitive Transcranial Magnetic Stimulation)
Initially, the higher cortical representation area (hotspot) of first right dorsal interosseous (FDI) muscle will be determined through a figure-eight coil connected to the magnetic stimulator (Rapid2, Magstim, UK) held manually and at 45 degrees from the midline, will be placed over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold (RMT) by finding the lowest stimulator output that elicit motor evoked potential (MEP) at least 50 microvolts (μV). After determined the RMT, the coil will be positioned over the scalp (Cz - 10/20 System). Thereafter, RMT will be measure. Low frequency protocol: 1Hz, 90% RMT, 1500 stimuli (1 train). After each rTMS session, presence of adverse effects will be computed
Sham rTMS
Volunteers will be submitted to sham session of repetitive transcranial magnetic stimulation
sham rTMS (repetitive Transcranial Magnetic Stimulation)
The hotspot of first right dorsal interosseous (FDI) muscle will be determinate through a figure-eight coil connected to the magnetic stimulator positioned over the motor primary cortex (C3). Then, the motor threshold (RMT) of FDI will be measure. Sham rTMS will be performed with low frequency (1Hz, 90% RMT, 1500 stimuli) protocol using two coils. The first one - connected to the stimulator - will be positioned on a coil support close to the volunteer but not visible. Therefore, characteristic stimulation noises will be audible. The second - disconnected to the stimulator - will be placed over primary motor area Cz. After each rTMS session, presence of adverse effects will be computed.
Interventions
Learn about the drugs, procedures, or behavioral strategies being tested and how they are applied within this trial.
High frequency rTMS (repetitive Transcranial Magnetic Stimulation)
Higher cortical representation area of first right dorsal interosseous muscle will be determined through a figure-eight coil connected to the magnetic stimulator (Rapid2, Magstim, UK) held manually and at 45 degrees from the midline over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold by finding the lowest stimulator output that elicit motor evoked potential at least 50μV. After determined the RMT, the coil will be positioned over the scalp (Cz - 10/20 System). Thereafter, RMT will be measure. rTMS protocols was based on previous studies. High frequency protocol: 10Hz, 90% RMT, 45 trains, 40 stimuli per train, inter interval of 28s, 1800 stimuli. After each rTMS session, presence of adverse effects will be computed.
Low frequency rTMS (repetitive Transcranial Magnetic Stimulation)
Initially, the higher cortical representation area (hotspot) of first right dorsal interosseous (FDI) muscle will be determined through a figure-eight coil connected to the magnetic stimulator (Rapid2, Magstim, UK) held manually and at 45 degrees from the midline, will be placed over the right primary motor cortex (C3 - 10/20 System). Then, will be determined the rest motor threshold (RMT) by finding the lowest stimulator output that elicit motor evoked potential (MEP) at least 50 microvolts (μV). After determined the RMT, the coil will be positioned over the scalp (Cz - 10/20 System). Thereafter, RMT will be measure. Low frequency protocol: 1Hz, 90% RMT, 1500 stimuli (1 train). After each rTMS session, presence of adverse effects will be computed
sham rTMS (repetitive Transcranial Magnetic Stimulation)
The hotspot of first right dorsal interosseous (FDI) muscle will be determinate through a figure-eight coil connected to the magnetic stimulator positioned over the motor primary cortex (C3). Then, the motor threshold (RMT) of FDI will be measure. Sham rTMS will be performed with low frequency (1Hz, 90% RMT, 1500 stimuli) protocol using two coils. The first one - connected to the stimulator - will be positioned on a coil support close to the volunteer but not visible. Therefore, characteristic stimulation noises will be audible. The second - disconnected to the stimulator - will be placed over primary motor area Cz. After each rTMS session, presence of adverse effects will be computed.
Other Intervention Names
Discover alternative or legacy names that may be used to describe the listed interventions across different sources.
Eligibility Criteria
Check the participation requirements, including inclusion and exclusion rules, age limits, and whether healthy volunteers are accepted.
Inclusion Criteria
* Incomplete Spinal cord injury thoracic or lombar levels
* Sensorio-motor impairment C or D according to American Spinal Cord Injury Association (ASIA)
* To be on chronic stage of injury (\> 8 months);
* Strength grade of hip flexors and knee extensors ≥ 1 according to Medical Research Council;
* Not to be a community walker
Exclusion Criteria
* Presence of metallic implant close to the target stimulation area
* Acute eczema under the target stimulation area
* Pacemaker
* History of seizures or epilepsy
* Hemodynamic instability
* History of neurological or orthopedic disease not related to spinal cord injury
* Cognitive impairment
* knee, ankle or hip flexor contracture superior to 20º;
* Changes on medication during the study execution
18 Years
40 Years
ALL
No
Sponsors
Meet the organizations funding or collaborating on the study and learn about their roles.
Universidade Federal de Pernambuco
OTHER
Responsible Party
Identify the individual or organization who holds primary responsibility for the study information submitted to regulators.
Kátia Monte-Silva
PhD
Principal Investigators
Learn about the lead researchers overseeing the trial and their institutional affiliations.
Kátia M Silva, PhD
Role: STUDY_DIRECTOR
Universidade Federal de Pernambuco
Locations
Explore where the study is taking place and check the recruitment status at each participating site.
Federal University of Pernambuco, Applied Neuroscience Laboratory
Recife, Pernambuco, Brazil
Countries
Review the countries where the study has at least one active or historical site.
Other Identifiers
Review additional registry numbers or institutional identifiers associated with this trial.
CNSexcit_SCI
Identifier Type: -
Identifier Source: org_study_id
More Related Trials
Additional clinical trials that may be relevant based on similarity analysis.