Comparison of Anatomical and Functional Outcomes of Laser Photocoagulation and Cryopexy in Patients with Rhegmatogenous Retinal Detachment Treated with Pneumatic Retinopexy

NCT ID: NCT06694259

Last Updated: 2024-12-19

Study Results

Results pending

The study team has not published outcome measurements, participant flow, or safety data for this trial yet. Check back later for updates.

Basic Information

Get a concise snapshot of the trial, including recruitment status, study phase, enrollment targets, and key timeline milestones.

Recruitment Status

RECRUITING

Clinical Phase

NA

Total Enrollment

40 participants

Study Classification

INTERVENTIONAL

Study Start Date

2024-12-18

Study Completion Date

2025-12-31

Brief Summary

Review the sponsor-provided synopsis that highlights what the study is about and why it is being conducted.

Rhegmatogenous Retinal Detachment is a pathological condition in which the inner layers of the retina separate from its outermost layer due to fluid entering between these layers through a retinal tear. Retinal detachment is one of the most urgent conditions in ophthalmology; if left untreated, it leads to severe vision loss and blindness. The only possible treatment is a surgical procedure to close the tear and reattach the separated retinal layers.

Currently, three techniques are used for surgically managing retinal detachment with a tear. You will undergo a technique called pneumatic retinopexy. In this procedure, reattachment of the retina is achieved by injecting sulfur hexafluoride gas (SF6) into the vitreous (the gel that fills the eye) about 4 millimeters from the corneal edge, using a very fine needle. The retinal tear is then closed by either freezing (cryotherapy) immediately before the gas injection or by laser photocoagulation after the gas is introduced.

The procedure will be done under local anesthesia, with the pupil first dilated using eye drops. After the procedure, a combination of antibiotics and corticosteroids will be instilled in the eye, followed by an ointment of the same combination, and the eye will be covered with a sterile dressing. You will need to maintain a specific head position, depending on the location of the retinal tear, for several days while the gas is present in the eye. This position helps the gas press against the tear, allowing it to heal. During this time, you should keep your head elevated, even at night, almost in a sitting position. Since the gas is lighter than the vitreous and rises within the eye, your head position should keep the tear positioned at 12 o'clock so the gas bubble can mechanically close it.

Proper patient selection is essential for this procedure: only patients with retinal tears limited to the upper half of the retina, with one or more tears within an hour area of the peripheral retina, are suitable for this technique. The gas does not need to be removed, as it will spontaneously reabsorb over 6-7 days. While it is in your eye, you will see it as a single bubble that will gradually shrink over 6-7 days before disappearing. If you experience severe pain on the first day, notify your surgeon, as gas expansion within the eye could cause a temporary rise in eye pressure in the first 24-48 hours.

You will need to remain in the same head position at home while the gas is present in your eye. While the gas is in place, you must not fly, as cabin pressure changes could cause the gas to expand. If you are unable to maintain the necessary position, this procedure may not be suitable for you, and an alternative technique would be needed.

This technique is less invasive than the two other surgical treatments for retinal detachment. It is performed under local anesthesia, is brief, carries fewer risks, and does not require additional follow-up procedures if the surgery is successful, which largely depends on your adherence to postoperative care.

Detailed Description

Dive into the extended narrative that explains the scientific background, objectives, and procedures in greater depth.

This study will include 40 patients with rhegmatogenous retinal detachment with one or more retinal breaks within two clock hours, limited to the upper half of the retina, who will be treated with pneumatic retinopexy. The patients will be thoroughly informed about the surgical procedure and the risks of potential complications. After a detailed clinical examination and the selection of suitable patients for this surgical method, the chosen patients will be randomized into two groups.

In the first group, patients will undergo transscleral cryopexy at the site of the retinal break (retrobulbar anesthesia will be given), guided by indirect ophthalmoscopy, during the same procedure. In the second group, after retinal reattachment, laser photocoagulation will be performed.

Before insufflation of the gas in the vitreous cavity, paracentesis of the anterior chamber will be performed to prevent increased intraocular pressure (0.2 mL of fluid will be withdrawn from the anterior chamber, with a 30-gauge needle). In both groups, patients will receive sulfur hexafluoride gas (SF6) in the vitreous space (0.5 mL). The gas will be injected with a 30-gauge needle, 3.5 or 4 mm from the corneal limbus (depending on the lens status: phakic/pseudophakic), at a moderate pace to avoid the formation of numerous little bubbles - a "fish eggs" phenomenon. Afterwards, evaluation of IOP will be performed by carefully evaluation of the central retinal artery for perfusion and confirmation of the light perception.

All patients will receive postoperative topical therapy with a combination of antibiotics and corticosteroids, and their head positioning will be adjusted according to the location of the retinal break(s) (positioned opposite to the retinal break for 5-8 days post-surgery, for 16 hours a day). Patients will receive appropriate hospital care and will be followed up in the retinal disease clinic postoperatively.

Conditions

See the medical conditions and disease areas that this research is targeting or investigating.

Rhegmatogenous Retinal Detachment

Keywords

Explore important study keywords that can help with search, categorization, and topic discovery.

Rhegmatogenous retinal detachment Pneumatic retinopexy Transscleral cryopexy Laser photocoagulation

Study Design

Understand how the trial is structured, including allocation methods, masking strategies, primary purpose, and other design elements.

Allocation Method

RANDOMIZED

Intervention Model

PARALLEL

Primary Study Purpose

TREATMENT

Blinding Strategy

TRIPLE

Participants Caregivers Investigators

Study Groups

Review each arm or cohort in the study, along with the interventions and objectives associated with them.

Pneumatic retinopexy with transscleral cryopexy

Group Type ACTIVE_COMPARATOR

Pneumatic retinopexy with transscleral cryopexy

Intervention Type PROCEDURE

Pneumatic retinopexy with transscleral cryopexy is a procedure used to treat certain types of rhegmatogenous retinal detachments.

Procedure steps:

Transscleral cryopexy: in this first step, the surgeon uses a cryoprobe applied to the sclera directly over the retinal tear. The cryoprobe emits extreme cold, creating a small, localized freeze that reaches the retina and seals the tear by causing a controlled scar to form. This scar tissue holds the retina in place and prevents further fluid from passing through the tear.

Gas bubble injection: after the cryopexy, a small gas bubble (usually sulfur hexafluoride (SF6) or perfluoropropane (C3F8)) is injected into the vitreous cavity. This bubble applies upward pressure on the retina, gently pressing it against the back wall of the eye, which aids in reattaching the retina.

Head positioning: for several days following the procedure, the patient must keep their head in a specific position so the gas bubble remains aligned with the retinal tear.

Pneumatic retinopexy with laser photocoagulation

Group Type ACTIVE_COMPARATOR

Pneumatic retinopexy with laser photocoagulation

Intervention Type PROCEDURE

Pneumatic retinopexy with laser photocoagulation is a minimally invasive procedure used to repair certain types of rhegmatogenous retinal detachments.

Procedure steps:

Gas bubble injection: a small gas bubble, usually sulfur hexafluoride (SF6) or perfluoropropane (C3F8), is injected into the vitreous cavity which rises and applies pressure to the detached retina, pressing it back against the eye wall and helping to reapproximate the retinal layers.

Laser photocoagulation: once the retina is positioned correctly, laser is used to create small burns around the retinal tear. This laser application causes a mild inflammatory response, creating a scar around the tear and effectively "welding" the retina to the underlying tissue. This seal prevents fluid from reaccumulating beneath the retina.

Head positioning: following the procedure, the patient must keep their head in a specific position for several days. This positioning ensures that the gas bubble stays aligned with the retinal tear.

Interventions

Learn about the drugs, procedures, or behavioral strategies being tested and how they are applied within this trial.

Pneumatic retinopexy with transscleral cryopexy

Pneumatic retinopexy with transscleral cryopexy is a procedure used to treat certain types of rhegmatogenous retinal detachments.

Procedure steps:

Transscleral cryopexy: in this first step, the surgeon uses a cryoprobe applied to the sclera directly over the retinal tear. The cryoprobe emits extreme cold, creating a small, localized freeze that reaches the retina and seals the tear by causing a controlled scar to form. This scar tissue holds the retina in place and prevents further fluid from passing through the tear.

Gas bubble injection: after the cryopexy, a small gas bubble (usually sulfur hexafluoride (SF6) or perfluoropropane (C3F8)) is injected into the vitreous cavity. This bubble applies upward pressure on the retina, gently pressing it against the back wall of the eye, which aids in reattaching the retina.

Head positioning: for several days following the procedure, the patient must keep their head in a specific position so the gas bubble remains aligned with the retinal tear.

Intervention Type PROCEDURE

Pneumatic retinopexy with laser photocoagulation

Pneumatic retinopexy with laser photocoagulation is a minimally invasive procedure used to repair certain types of rhegmatogenous retinal detachments.

Procedure steps:

Gas bubble injection: a small gas bubble, usually sulfur hexafluoride (SF6) or perfluoropropane (C3F8), is injected into the vitreous cavity which rises and applies pressure to the detached retina, pressing it back against the eye wall and helping to reapproximate the retinal layers.

Laser photocoagulation: once the retina is positioned correctly, laser is used to create small burns around the retinal tear. This laser application causes a mild inflammatory response, creating a scar around the tear and effectively "welding" the retina to the underlying tissue. This seal prevents fluid from reaccumulating beneath the retina.

Head positioning: following the procedure, the patient must keep their head in a specific position for several days. This positioning ensures that the gas bubble stays aligned with the retinal tear.

Intervention Type PROCEDURE

Eligibility Criteria

Check the participation requirements, including inclusion and exclusion rules, age limits, and whether healthy volunteers are accepted.

Inclusion Criteria

* Patients with rhegmatogenous retinal detachment with one or more tears within two clock hours, limited to the upper half of the retina

Exclusion Criteria

* Patients with tears in the lower half of the retina
* Patients with multiple retinal tears covering more than two clock hours
* Patients with developed proliferative vitreoretinopathy
* Patients with vitreous hemorrhage
* Patients with opaque optical media due to other conditions that could obstruct a detailed fundus examination or the procedure itself
* Patients unable to follow postoperative head positioning instructions
* Patients under age of 18 years
Minimum Eligible Age

18 Years

Eligible Sex

ALL

Accepts Healthy Volunteers

No

Sponsors

Meet the organizations funding or collaborating on the study and learn about their roles.

Clinical Hospital Center, Split

OTHER

Sponsor Role lead

Responsible Party

Identify the individual or organization who holds primary responsibility for the study information submitted to regulators.

Ivan Borjan

Ophthalmologist

Responsibility Role PRINCIPAL_INVESTIGATOR

Principal Investigators

Learn about the lead researchers overseeing the trial and their institutional affiliations.

Ivan Borjan, MD

Role: PRINCIPAL_INVESTIGATOR

Clinical Hospital Center, Split

Locations

Explore where the study is taking place and check the recruitment status at each participating site.

Clinical Hospital Center, Split

Split, , Croatia

Site Status RECRUITING

Countries

Review the countries where the study has at least one active or historical site.

Croatia

Central Contacts

Reach out to these primary contacts for questions about participation or study logistics.

Ivan Borjan, MD

Role: CONTACT

Phone: +385981715350

Email: [email protected]

Ljubo Znaor, prof.

Role: CONTACT

Email: [email protected]

Facility Contacts

Find local site contact details for specific facilities participating in the trial.

Ivan Borjan, MD

Role: primary

Ljubo Znaor, prof.

Role: backup

Ivan Borjan, MD

Role: backup

Ljubo Znaor, prof.

Role: backup

Other Identifiers

Review additional registry numbers or institutional identifiers associated with this trial.

2181-147/01/06/LJ.Z.-23-02

Identifier Type: -

Identifier Source: org_study_id