Compared Unidirectional Valve Apparatus and Occluding the Non-ventilated Endobronchial Lumen for Lung Collapse.

NCT ID: NCT06210256

Last Updated: 2024-01-18

Basic Information

• Recruitment Status: NOT_YET_RECRUITING
• Clinical Phase: NA
• Total Enrollment: 192 participants
• Study Classification: INTERVENTIONAL
• Study Start Date: 2024-01-25
• Study Completion Date: 2024-06-25

Brief Summary

With the rapid advancement of thoracoscopic surgery in recent years, surgeons have set higher standards for the quality of non-ventilated lung collapse. In a prior investigation, we examined a unidirectional valve device that let air exit the non-ventilated side of the lung but not enter during ventilation and showed the use of this device during one-lung ventilation (OLV) for patients undergoing thoracoscopic surgery could speed up lung collapse, lower endogenous positive end-expiratory pressure, and have no discernible effects on oxygenation. In light of this, we conducted this study to further demonstrate, by comparison with the commonly used clinical technique of occluding the non-ventilated endobronchial lumen during one-lung ventilation, that this unidirectional valve device can quicken and enhance the quality of lung collapse without raising the risk of adverse events when used in thoracoscopic surgery.

Detailed Description

In this study, patients who meet the enrollment criteria will be randomized 1:1 to the unidirectional valve group or the closed lumen group.

After patients entered the operating room, their heart rate, mean arterial pressure, electrocardiogram, and pulse oxygen saturation were monitored. The electrodes of a bispectral index (BIS) Vista monitor were placed on the patient's forehead. The mask for oxygen inhalation at 6 L/min was then applied. Anesthesia was induced with 2mg midazolam, 0.3ug/kg sufentanil, 2-3mg/kg propofol and 0.3mg/kg cisatracurium using ideal body weight. Patients were intubated using a video double-lumen endotracheal tube [Disposable sterile double-lumen tracheal intubation, Nortier] by a senior anesthesiologist. Following confirmation of the double-lumen tube (DLT) placement position, two-lung ventilation was started at a respiratory rate of 15 breaths per minute, with an inspiratory to expiratory (I: E) ratio of 1:2, tidal volume of 8 ml/kg, and an inspired oxygen fraction (FiO2) of 0.8. Remifentanil (0.05-0.3 ug/kg/min) and propofol (4-12 mg/kg/h) were continuously infused to maintain anesthesia while the levels of BIS fluctuated between 40 and 60. The DLT placement location was verified again as soon as the disinfection and draping process started, and one-lung ventilation was initiated. In this study, we used a disposable plastic membrane glove and chopped off the fingers to create a unidirectional valve device. Our prior clinical experiment showed that this device permits gas in the non-ventilated lung to exit during exhalation, while ambient air could not enter via the collapsed cut hole during inhalation. In the unidirectional valve group, as soon as disinfection and draping began, the lumen of the Y-connector to the non-ventilated lung was clamped and the unidirectional valve device was fastened to the bronchoscope port of the tracheal lumen to initial the one-lung ventilation. In the closed lumen group, as soon as disinfection and draping began, the lumen of the Y-connector to the non-ventilated lung was clamped, and the bronchoscope port of the tracheal lumen was sealed off from the atmosphere until pleural opening. When the pleura opened, the bronchoscope port opened to the air for 30 seconds before closing once more until the one-lung ventilation was completed. The tidal volume was adjusted to 6 ml/kg during OLV, and the respiratory rate was set to 15 breaths per minute with a I:E ratio of 1:2 and FiO2 of 0.8. Positive expiratory pressure was not applied in this trial. After pleural opening, the thoracoscopic surgery procedure was captured on video using an electronic equipment. The anesthesiologist, who was blind to the specific lung collapse technique, watched the recordings after surgery and used a visual analogue scale to assess the quality of lung collapse at various time points. Bronchial suction was employed to foster lung collapse of the non-ventilated lung if there was no collapse or partial collapse of the lung during the surgical procedure. The number and timing of bronchial suction should be documented in detail. After surgery, patients were transferred to the post-anesthesia care unit (PACU) for continued monitoring. Throughout their hospital stay, the patients were visited daily, and any postoperative pulmonary issues were recorded in time until the patients were released from the hospital.

Conditions

Video-assisted Thoracoscopic Surgery; One-Lung Ventilation

Study Design

• Allocation Method: RANDOMIZED
• Intervention Model: PARALLEL
• Primary Study Purpose: OTHER
• Blinding Strategy: QUADRUPLE

Study Groups

the unidirectional valve group

In the unidirectional valve group, as soon as disinfection and draping began, the lumen of the Y-connector to the non-ventilated lung was clamped and the unidirectional valve device was fastened to the bronchoscope port of the tracheal lumen to initial the one-lung ventilation.

Group Type: EXPERIMENTAL

unidirectional valve apparatus

Intervention Type: PROCEDURE

In the unidirectional valve group, we attached the unidirectional valve device to the lumen's distal port when one-lung ventilation initiated.

the closed lumen group

In the closed lumen group, as soon as disinfection and draping began, the lumen of the Y-connector to the non-ventilated lung was clamped, and the bronchoscope port of the tracheal lumen was sealed off from the atmosphere until pleural opening. When the pleura opened, the bronchoscope port opened to the air for 30 seconds before closing once more until the one-lung ventilation was completed.

Group Type: ACTIVE_COMPARATOR

occluding the non-ventilated endobronchial lumen

Intervention Type: PROCEDURE

In the closed operative lumen group, we closed the lumen's distal port of non-ventilated lung when one-lung ventilation initiated.

Interventions

unidirectional valve apparatus

In the unidirectional valve group, we attached the unidirectional valve device to the lumen's distal port when one-lung ventilation initiated.

Intervention Type: PROCEDURE

occluding the non-ventilated endobronchial lumen

In the closed operative lumen group, we closed the lumen's distal port of non-ventilated lung when one-lung ventilation initiated.

Intervention Type: PROCEDURE

Eligibility Criteria

Inclusion Criteria

• Age: 18-75 years old
• American Society of Anesthesiologists (ASA) physical status I to III
• Patients scheduled to undergo video-associated thoracoscopic surgery requiring one-lung ventilation

Exclusion Criteria

A - pre-operative

1. anticipated difficult intubation

2. New York Heart Association (NYHA) heart failure class III/IV

3. body mass index≥35kg/m2

4. patients with abnormal expiratory recoil [forced expiratory volume in 1s (FEV1) less than 70% of predicted values

5. chronic obstructive pulmonary disease (COPD) or severe asthma

6. prior thoracic surgery or radiotherapy

7. a history of pleural or interstitial disease

B - post-randomization

1. the discovery of pleural adhesions following pleural opening

2. a delay of more than 25 minutes between the onset of one-lung ventilation and chest opening

3. the duration between the onset of one-lung ventilation and chest opening less than 10 minutes

4. a switch to thoracotomy as the type of surgical procedure

5. he occurrence of significant adverse events during the operation, such as severe bleeding (more than 1500ml), fatal arrhythmia, respiratory arrest, or cardiac arrest

• Minimum Eligible Age: 18 Years
• Maximum Eligible Age: 75 Years
• Eligible Sex: ALL
• Accepts Healthy Volunteers: No

Sponsors

Sichuan University

OTHER

Sponsor Role: lead

Responsible Party

Peng Liang，MD

Professor

Responsibility Role: PRINCIPAL_INVESTIGATOR

Principal Investigators

Peng Liang, PhD

Role: STUDY_DIRECTOR

West China Hospital

Locations

West China Hospital

Chengdu, Sichuan, China

Countries

China

Central Contacts

Peng Liang, PhD

Role: CONTACT

liangpengwch@scu.edu.cn

18980602201

Facility Contacts

Peng Liang, PhD

Role: primary

liangpengwch@scu.edu.cn

18980602201

Other Identifiers

2023HXFH012

Identifier Type: -

Identifier Source: org_study_id